How to Easily Raise Low Pool pH

Theodore Jones Low pH Low pool pH Optimum pool pH Pool pH levels Pool pH tips Pool water itchy skin Pool water red eyes Raise pool pH Soda ash Soda ash granular formula Soda ash increase pH Sodium carbonate

Summer is just around the corner! It’s almost time to uncover your pool for some fun in the sun. But before you start doing cannonballs and playing Marco Polo, you need to check your pool through-and-through. That includes checking your pool’s pH.

If your pool’s pH is too low, your plumbing will start to corrode, your equipment will begin to fail, and your swimmers will start to complain about skin and eye discomfort.

Instead of suffering from red eyes and itchy skin, invest in an easy-to-use sodium carbonate granular formula to increase your pool’s pH. Whether you’re new to pool maintenance or just need a refresher, here’s everything you need to know about adjusting a low pool pH.

What happens when my pool’s pH is too low?

The perfect pH level for your pool is between 7.2 and 7.6. Anything lower and you could start to experience a number of unwanted issues, including:

  • Red eyes
  • Itchy skin
  • Irritated nasal cavities
  • Damaged equipment
  • Ineffective chlorine
  • Tinted water

How do I increase my pool pH?

You can raise your pool’s pH in four easy steps:

Step 1: Check your pool’s pH

It’s hard to know your pool’s pH if you don’t know how to check it in the first place! Some different types of pool testing kits include:

  • Liquid test kits
  • Strip test kits
  • Digital test kits

Depending on your budget and needs, you can decide which is best for you. Each option gives clear and accurate pH results—although some kits are faster than others.

If your pool’s pH is below 7.2, it’s time to raise it.

Step 2: Know how much water is in your pool

When you buy a pool, you probably knew how many gallons of water your pool holds. But maybe you lost your paperwork or just forgot over the years. No problem! Here’s a great pool volume calculator.

Step 3: Measure the amount of sodium carbonate (soda ash)

The most common question involving pool pH tends to be: How much sodium carbonate do I use to increase the pH? It may seem like a challenge at first, but the process is actually quite easy. If you’re using soda ash from Factory Direct Chemicals, just use this simple chart:

Pour the soda ash slowly into the pool and turn on your pump so the granular formula distributes throughout the pool.

Step 4: Retest your pool’s pH levels

Let the soda ash mix in and stabilize for a couple of hours. Then check your levels again. You may need to make some slight adjustments to get your levels perfect. If your numbers look good, then you’re good to start swimming.

How can I keep my pool’s pH at an optimal level?

No matter how well you take care of your pool, there will always be some fluctuation in the pH levels. But there are some steps you can take to keep the fluctuations at a minimum, including:

  • Skimming debris like leaves and sticks
  • Testing your chemical levels consistently
  • Vacuuming and brushing at least once a month
  • Keeping your filters clean
  • Maintaining internal equipment yearly

It’s easy to increase the pH when needed with a soda ash granular formula. Don’t put off correcting low levels because you think you will struggle with tough equations. Following the easy steps above will protect your skin, eyes, and your entire pool investment. Now get your bathing suit, polish your sunglasses, and get out there and enjoy the summer season!


Older Post Newer Post


Leave a comment